Ingress

Compliant Kubernetes (CK8s) uses the Ingress NGINX Controller to route external traffic to the correct Service inside the cluster. CK8s can configure the Ingress Controller in two different ways depending on the underlying infrastructure.

Using a Service of type LoadBalancer

When using a Infrastructure Provider with a Kubernetes cloud integration such as AWS, Azure and Google cloud the Ingress controller can be exposed with a Service of type LoadBalancer. This will create an external load balancer in the cloud provider with an external ip-address. Any dns records should be pointed to the ip-address of the load balancer.

Note

This is only currently supported in CK8s for AWS. It is however possible to configure this for Azure and Google cloud as well but it's not done by default

Using the host network

For any Infrastructure Provider (or bare metal) not supporting these kind of public load balancers the Ingress Controller uses the host network instead. This is done by configuring the Ingress Controller as a DaemonSet so one Pod is created on each node. The Pods are configured to use the host network, so all traffic received on the node on port 80 and 443 will be intercepted by the Ingress Controller Pod and then routed to the desired Service.

On some clouds providers there is load balancing available for the worker nodes. For example Exoscale uses an "elastic ip" which provides one external ip which load balances to the available worker nodes. For these Infrastructure Providers this external ip of the load balancers should be used as the entry point in the dns.

For the Infrastructure Providers where this is not available the easiest option is to just point the dns to the ip of any, or all, of the worker nodes. This is of course not a optimal solution because it adds a single point of failure on the worker node which is selected by the dns. Another option is to use any existing load balancer service if this is available.

Installation

The Ingress NGINX Controller is currently configured and installed by the compliantkubernetes-apps repository. The configuration is set in sc-config.yaml and wc-config.yaml under:

ingressNginx:
  useHostPort: ""
  service:
    enabled: ""
    type: ""

If the apps repository is initiated with the correct Infrastructure Provider these config options will get the correct defaults.

For more ways to install the Ingress NGINX Controller see the upstream documentation.

Ingress resource

The Ingress resource is used to later route traffic to the desired Service. For more information about this see the official documentation.